nowhere does it say this: "note: when using metal foil to cover accessories, pans and dishes, it is recommended that the wire rack be in the middle or bottom location." and "be sure that the metal
it comes with the pizza pan, a broiler tray and of cource the wire rack that goes inside, very easy to follow instructions too.
someone mentioned in a previous review that the cord is a bit short, but it's not any shorter than cords on other toaster ovens or small kitchen appliances we've owned in the past.
- the cord is a little short (less than 3 feet) - while many people may appreciate a short cord it does mean that you have to have outlet near a space where you plan to use the oven.
i prefer my old wire 9 x 13 wire broiling rack and much deeper pan from the b & d and have kept it to use for broiling.
after turning it on and plugging in all my equipment, i found i was only using 45% of the 850va.
take it out of the box, plug it in, wait the 16 hours or so for a full charge and plug in the devices that need to be protected.
very easy to use, all i did was plug it into my computer and after answering a few questions on the computer it was ready to use.
the cool feature is that it tells you how much time you have left on the charge depending on what you have plugged in.
i haven't had a power outage yet, but i've pulled the plug and waited a good bit before plugging it back in.
ordered it - got it in a couple of days - plugged it in & we're off and running.
i loved that i could just plug it in between my hardware and my ac power and was good to go!
you will plug several more devices into it than ever planned.
plugged it in and forgot about it.
after initially charging the ups battery, i plugged the nas power cord in on the battery backup side and hooked up the interface cable.
this is my highest va unit so far, but only have a voip unit, router, network switch, and cable modem plugged into it.
i plugged it in, plugged in all my computer stuff.
no need to read manual during setup, put the battery in then connect the plugs you are up and running.
it's great for sensitive recording equipment as the plug was pulled out accidently during a session and we lost no data...
however they manufactured it with only one (1)female outlet capable of handling those wide black transformer plugs on the power backup row of four(4).
we plugged it in and charged for 24 hours and have been using it since.
the ups is plugged into my mac via usb and, based on my settings in system preferences, the ups shut down my computer when 5 minutes remained or the battery had 15% life remaining, whichever came
has worked terrific since i plugged it in.
especially in our old house, where the quality of the electrical wires can be suspect, it insulates the expensive equipment from over and under voltages.
initially i did not plug usb cable and had hard time trying to understand why pc does not see it.
it has alot of plugs, but didn't have a couple plugs that my case needed for the case fans.
only thing i have seen more convenient are the psu's where you plug in only the wires you need to it, so none left dangling in the case.
only minor issue is the bundle of cords that takes up alot of space inside the case.
never have a lick of problem , plenty of additional lines and plugs for upgrading , all nicely wrapped and insulated, plenty of power and never know the fan is on,excellent for my system.
its not modular and some of the wires interfere with my cpu fan, but its a smooth, simple, easy psu with tons of power.
i am disappointed in the projected backup time based on being plugged into my tv when it is turned off.
(load, input voltage, output voltage, etc.) easy to set up, just plug in.
in a basic test of the system (disconnecting the power cord), it reported that it would hold my computer and monitor up for about 22 minutes.
bottom line - would recommend the product but wish there was wider spacing between plugs as hard to accommodate transformers.
just make sure you pick the correct capacity for what you want to plug into it.
we have a problem with our older house's wiring -- every time the heating/ac kicks on there's a brief power lag.
simple plug and go.
they don't show you the back of the unit, but it is very nicely set up with plugs for each of your components.
has a massive power cord but connects easily into the wall with a right angle plug.
difficult to setup, plenty of outlets to plug in your equipment.
i work from home a lot and power stability for my voip, cable modem, and wireless environment are paramount to keep me productive.
i would totally recommend this unit - it gives 16 minutes of runtime during a power failure, and this includes running my voip phones, a 19 inch monitor, 2 modems, & a wireless router , in addition
no issues with setup, basically you just plug it in.
i also keep a desk lamp plugged into it, so if the power goes, i still have some light to work by while i save everything & shut down.
usb connectivity works well with windows xp to have it safely shutdown.cons: usb connection doesn't work as seemlessly with suse linux 10.1 (meaning it isn't simply plug and play).
this ups will sometimes shut itself down for no reason, meaning the batery and sourge protected outlets will lose power and all equipment and computer plugged into these outlets will lose power.
very simple to setup, just plug it into the wall and check after a few hours to make sure it's charged.
tried plugging and un-pluggling the unit with all my equipment on and it held power for the 5 minutes i let it run on batteries.
as far as functionality, i have all the back up plugs connected, and the device does allow for ample time to back up computer files when the power goes off.
- the end of the power cord should be flat, and not the typical pc cord.
unfortunately, when i plugged in the unit and once the load was turned on, it started humming loudly and the metal cover on top even started vibrating, thus making even more noise.
i currently have my computer,monitor, modem, voip and router plugged into, whole system pulls 220 watts at idle.
the back-ups rs models have both 1-line 2-wire phone/fax/modem data-line protection and 10/100base-t ethernet protection, where as the back-ups xs models only has 1-line 2-wire phone/fax/modem
if you follow along, they would have your system shut down for 16 hour to charge the back battery after they have you plugged your equipment into it.
extra plug ins for surge protection only.
pros: lots of va for the $both 2003 server and 2000 server plug and played them.
macs recognize this unit immediately when plugged in via usb and have built-in settings for ups in the energy-saver preferences box.
keep that unit plugged into another outlet.
when i plugged it in, a bad smell filled the room.
Compare UPS Systems Devices for Wiring »
Wize.com wants to improve! Will you please help by taking a quick survey?
No Thanks